Latest revision as of 13:21, 16 December 2015

UPS

We can monitor two of our UPSs via SNMP from any host on our 10.15.134.0/24 subnet (see Machine List):

Install snmp and snmp-mibs-downloader (note: snmp-mibs-downloader is not available in stretch repository, so just download the deb from sid).

Run `download-mibs`

   snmpget -v 1 -c MSO mc-3015-h7-ups-1.cs.uwaterloo.ca PowerNet-MIB::upsBasicOutputStatus.0

This will return something like:

   PowerNet-MIB::upsBasicOutputStatus.0 = INTEGER: onLine(2)

@@ Line 1: / Line 1: @@
-== Debian ==
+= UPS =
+We can monitor two of our UPSs via SNMP from any host on our 10.15.134.0/24 subnet (see [[Machine_List#UPS|Machine List]]):
-* sudo apt-get install snmpd
-* sudo nano /etc/default/snmp
-** Remove the 127.0.0.1 part in the SNMPDOPTS line
-* sudo nano /etc/snmp/snmpd.conf
-** Remove the following line: com2sec paranoid  default         public
-** Under the existing com2sec lines, add the following: com2sec readonly  129.97.134.36 public
-** If you want to query locally, you can add this line: com2sec readonly  127.0.0.1/24 public
-** Find the lines starting with syslocation and sysconact and fill them in accordingly
-* sudo invoke-rc.d snmpd restart
+== Debian Setup ==
-If you want to enable sensors, you'll need to get lm-sensors installed and working. Then you'll need to restart snmpd (sudo invoke-rc.d snmpd restart).
+Install snmp and snmp-mibs-downloader (note: snmp-mibs-downloader is not available in stretch repository, so just download the deb from sid).
+Download https://nagios.cscf.uwaterloo.ca/kiosk/powernet416.mib and place it in /usr/share/snmp/mibs
+Run `download-mibs`
+== Getting Status ==
+    snmpget -v 1 -c MSO mc-3015-h7-ups-1.cs.uwaterloo.ca PowerNet-MIB::upsBasicOutputStatus.0
+This will return something like:
+    PowerNet-MIB::upsBasicOutputStatus.0 = INTEGER: onLine(2)